How do you encode video door entry units art. 6329 and art. 6309 (Giotto Series), setting the primary and secondary identifier?
Set the primary identification code as follows:
- pick up the handset
- hold down the RESET button (black button on the lower part of the monitor near the handset cable outlet)
- hold down the LOCK button (the first of the three vertical buttons on the front of the video door entry unit)
- release the RESET button
- wait for the “beep” (after approx. 2 seconds) and then release the LOCK button
- (the monitor and the video door entry audio system now come on and communicate with the main panel)
- press the button on the panel within 30 seconds to call the video door entry unit being encoded
- if the identifier has been set correctly, the video door entry unit will emit a "beep" 2 seconds after pressing the button on the plate, and will then switch off.
Set the secondary identification code as follows:
- pick up the handset
- hold down the RESET button
- press LOCK and AUTO-ON (the button with the square symbol) and hold down together with the RESET button
- release the RESET button
- wait for the "beep” (after approx. 2 seconds) and then release the LOCK and AUTO-ON buttons
- (the monitor and the video door entry audio system now come on and communicate with the main panel)
- press the button on the panel within 30 seconds to call the video door entry unit being encoded
- if the identifier has been set correctly, the video door entry unit will emit a "beep" 2 seconds after pressing the button on the plate, and will then switch off.
Important: manually, it is only possible to encode up to a maximum of 3 units. For more units, use the Elvox programmer or the SaveProg Software.